Aeon Labs Aeotec Multisensor 6?
Aeon Labs Aeotec Multisensor 6?
Just got an Aeon Labs Aeotec Multisensor 6, but all I can get out of it is temperature. Would at least like to see humidity too. Is this possible?
Re: Aeon Labs Aeotec Multisensor 6?
Give Z-Command about an hour to query it (depending on the pre-set wake-up interval).
Alternatively, wake the sensor by pressing the button on it and query it immediately from Z-Command.
We have not tested the Multisensor 6 but we expect it to list all sensors.
Alternatively, wake the sensor by pressing the button on it and query it immediately from Z-Command.
We have not tested the Multisensor 6 but we expect it to list all sensors.
Re: Aeon Labs Aeotec Multisensor 6?
Still only showing temps after 2 hours. I might try removing it and adding it back.
This one is weird, it doesn't act like I thought it would. Seems like it only reports on its wakeup interval, and the shortest interval I can set it 240 seconds.
Let me know if there's anything I can do to help with this one.
This one is weird, it doesn't act like I thought it would. Seems like it only reports on its wakeup interval, and the shortest interval I can set it 240 seconds.
Let me know if there's anything I can do to help with this one.
Re: Aeon Labs Aeotec Multisensor 6?
No luck at all for anything but temperatures.
Upgraded the firmware on the sensor, no dice.
Disappointed in this one.
Upgraded the firmware on the sensor, no dice.
Disappointed in this one.
Re: Aeon Labs Aeotec Multisensor 6?
I'm not even getting temp consistently. Any info on how you did that?
Re: Aeon Labs Aeotec Multisensor 6?
I just bought one of these units. I'm getting temps, humidity, and luminance readings okay, but I can't seem to trigger the motion sensor
Re: Aeon Labs Aeotec Multisensor 6?
Make sure the sensor is associated with the controller (node 1).thearn wrote:I just bought one of these units. I'm getting temps, humidity, and luminance readings okay, but I can't seem to trigger the motion sensor