Raspberry PI I/O

Let us know which devices you've used successfully with Z-Command
poordom
Posts: 6
Joined: Wed Aug 19, 2015 11:54 am

Raspberry PI I/O

Postby poordom » Wed Aug 19, 2015 12:00 pm

Good afternoon All,

I am looking at purchasing the Z-Command.

I was wondering, since the Z-Command is a Raspberry PI, can the supplied software take advantage of the I/O located on the card.

Like the Digital input and the Analog inputs, and integrate their status for automation purposes.


Thanks

Dom

admin
Site Admin
Posts: 50
Joined: Sun Dec 14, 2014 2:05 pm
Location: Washington
Contact:

Re: Raspberry PI I/O

Postby admin » Sat Aug 22, 2015 6:30 am

Hi Dom,

Z-Command does not currently directly read the GPIO pins, but there is absolutely nothing stopping you from writing a script that reads the pins and then internally call Z-Command APIs.

poordom
Posts: 6
Joined: Wed Aug 19, 2015 11:54 am

Re: Raspberry PI I/O

Postby poordom » Sat Aug 22, 2015 11:21 am

That could be a difficult task.

Asking me to write a script, would be just as bad as asking me to run a marathon, I weigh 280 Lbs, I could probably roll faster that run.

Thanks

Dom :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll: :roll:

admin
Site Admin
Posts: 50
Joined: Sun Dec 14, 2014 2:05 pm
Location: Washington
Contact:

Re: Raspberry PI I/O

Postby admin » Sat Aug 22, 2015 11:32 am

Ok. But if you decide to give writing a console application in C# a shot (mono is already installed on z-command), here are a few libraries to get you started:

* https://github.com/raspberry-sharp/raspberry-sharp-io
* https://github.com/andycb/PiSharp

You can also email support@intulon.com for more information.


Return to “Compatible hardware”

Who is online

Users browsing this forum: No registered users and 1 guest

cron